[Amended 8-3-2020 by Ord. No. 20-22]
A final plat prepared by a Wisconsin professional land surveyor shall be required for all subdivisions and large lot subdivisions. Such plat shall comply in all respects with the requirements of § 236.20, Wis. Stats., as amended from time to time, and the provisions of this chapter. The final plat shall be submitted in an electronic media format acceptable to the Village and compatible with the Village's Geographic Information System format.
The final plat shall show correctly on its face, in addition to the information required by § 236.20, Wis. Stats., each of the following:
A. 
Exact length and bearing of the center line of all streets.
B. 
Exact street width along the line of any obliquely intersecting street.
C. 
Setbacks or building lines required by the Village Board in accordance with the guidelines set forth in § 395-64 of this chapter.
D. 
Utility and drainage easements.
E. 
All lands to be dedicated or reserved for future public acquisition or reserved for the common use of property owners within the plat.
F. 
All lands affected by special restrictions required by the Village Board, such as those relating to access control along public ways, the provision of planting strips or detention or retention facilities.
G. 
A copy of the final plat on an electronic media compatible with the Village's Geographic Information System pursuant to § 395-82A of this chapter shall be filed with the Village.
H. 
Any other information required by the Village staff, Village Plan Commission or Village Board.
The Village Board shall require that dedications and easement restrictions, running with the land and enforceable by the Village, be recorded with the final plat to accomplish the purposes and intent of this chapter. A draft of the final plat shall first be submitted to the Village staff for review, comment and addition of the dedications and easements language prior to submittal to the Village Plan Commission and Village Board for final approval.
A. 
Examination; field checks. The Village staff shall examine all final plats within the Village and may make, or cause to be made by a Wisconsin professional land surveyor under the supervision or direction of the Village Administrator, field checks for the accuracy and closure of survey, the proper kind and location of monuments and the legibility and completeness of the drawing.
[Amended 8-3-2020 by Ord. No. 20-22]
B. 
Exterior boundaries. Maximum error of closure before adjustment of the survey of the exterior boundaries shall not exceed, in horizontal distance or position, the ratio of one part in 10,000 or, in azimuth, of four seconds of arc per interior angle. If field measurements exceed this maximum, new field measurements shall be made until a satisfactory closure is obtained. When a satisfactory closure of the field measurements has been obtained, the survey of the exterior boundary shall be adjusted to form a closed geometric figure.
C. 
Interior boundaries. All street, block and lot dimensions shall be computed as closed geometric figures based upon the control provided by the closed exterior boundary survey. If field checks disclose an error for any interior line of the plat greater than the ratio of one part in 5,000 or an error in measured angle greater than one minute of arc for any angle where the shorter side forming the angle is 300 feet or longer, necessary corrections shall be made. Where the shorter side of a measured angle is less than 300 feet in length, the error shall not exceed the value of one minute multiplied by the quotient of 300 divided by the length of the shorter side; however, such error shall not in any case exceed five minutes of arc.
D. 
Engineer's examination. The Village Board shall receive the results of the Village Engineer's examination prior to approving the final plat.
When the final plat is located within a United States Public Land Survey quarter-section, the corners of which have been relocated, monumented and coordinated by the Village of Pleasant Prairie, Kenosha County or the Southeastern Wisconsin Regional Planning Commission, the plat shall be tied directly to one of the section or quarter corners so relocated, monumented and coordinated. The exact grid bearings and distances of such tie shall be determined by field measurements, and the material and Wisconsin state plane coordinates of the monument marking the relocated section or quarter corner to which the plat is tied shall be indicated on the plat. All distances and bearings shall be referenced to the Wisconsin Coordinate System, South Zone, and adjusted to the Kenosha County control survey.
All final plats shall provide all the certificates required by § 236.21, Wis. Stats., and, in connection with the owner's or mortgagee's certificate, the owner shall submit, as a condition of the Village Board's final approval of the final plat, an appropriately updated abstract of title, commitment to issue a policy of title insurance from a title insurance company, policy of title insurance equal to the total amount of the letter of credit, or a certificate of title from an abstracting company. In addition, the surveyor shall certify that he has fully complied with all of the provisions of this chapter.
[Amended 8-3-2020 by Ord. No. 20-22]
The final plat shall only be recorded with the Kenosha County Register of Deeds after final approval by the Village Board, after verification is provided that all outstanding taxes and special assessments are paid in full, and after all required certificates are attached to or inscribed thereon. The approved final plat shall be recorded by the divider within 12 months after the date of required approval and within 36 months after the date of the first preliminary plat approval. A copy of the final plat recording information shall be provided to the Village within 72 hours of recording.
A. 
Types. Correction instruments relating to recorded final plats may be recorded in the Kenosha County Register of Deeds office and may include:
(1) 
Affidavits to correct distances, angles, directions, bearings, chords, block or lot numbers, street names or other similar details shown on a recorded final plat, which shall be approved by the Village Board, prior to recording, after review and recommendation of the Plan Commission.
(2) 
Ratifications of a recorded final plat, signed and acknowledged in accordance with § 706.07, Wis. Stats.
(3) 
Certificates of owners and mortgagees of record at the time of recording.
B. 
Limitation on use. Correction instruments shall create neither new buildable lots nor nonconforming lots.